probably going to get flamed for having a built d16 boosted by a 14b



14b
d16y7 head and block
eagle rods, srp a6 pistons ~9.6:1 c/r in the y7
arp head studs
delta 272 cam
fidanza flywheel exedy organic clutch
z6 intake manifold
rx7 460 injectors
knockoff type rs bov
forge intercooler
2.5" homemade charge piping and downpipe
street tuned with crome and lc-1 wideband



trailer trashn.

 

solid setup man! but that motor can take a much bigger beating than the 14b can dish out. although thats a great turbo for the streets. fast spooler!

-Luke

 

How much boost are you running?

 

Awesome man I have a similar built setup with a little less compression and I'll be running a 14b as well to start.
d16z6
9:1 cp pistons from a y8
eagle rods
arp studs
dsm 450cc
jrc 8"
3"dp to 3" magnaflow exhaust with wg tie in

I'll be running bbka's street tune as a basemap, the only differences being 3" exhaust and lower compression.

 

good ---- dude! max out that 14b and have some fun!

 

8 lbs for a bit, then turning the boost up as high as i think i can go 14-15 psi with the motorola sound good?


i used a basemap from **** i found on xenocron

 

DSMer's push those bitches to 18-20psi(wouldn't recomend, but hey, you can)

 

where have you been uberdata is so outdated and no bbka bin wont transfer to crome correctly.



crome is the future

 

That's funny, on xeno's website it's under the Crome section. It's just the bin I've been using, I haven't tried to open it with Crome. Was ****'s 15g basemap in the Crome section created by Crome?

EDIT: My bad, it is not bbka's basemap I'm using, but rather one by **** now that I have gone back over the Crome section of the roms.
Was this one:
450cc-14b-crome-p28-19deg-v3dl
d16z6/Hf Mani/14b turbo/450cc/p28/streetwidebandbasemap/jrc 8 inch/2.5" DP/2.5" charge pipes
Created in Crome? That's the bin I have burned. Sorry about the bbka mixup.

 

14b's wake up at 14psi...all depends on your power goal and cfm demand.