crx t25 - o2 housing/downpipe question
sorry if this has been covered... Ive searched and been reading up, but I havent found much info on this particular issue.
setup: d16a6, hf manifold, dsm t25 turbo From reading Abaz's comment, the o2 housing/downpipe will not clear the cross member on the crx without cutting it up. I was wondering how many of you actually did this? and how hard was it? Or, would it be easier buying a flange from BMC and having an exhaust shop make the downpipe tubing? tia |
Re:crx t25 - o2 housing/downpipe question
make a DP you're better off that way.
|
Re:crx t25 - o2 housing/downpipe question
you can "Notch" the front cross member if you are comfortable with that, but the DP is going to make a very sharp bend in order to come back up since it will be sitting fairly low. Your better off buying a o2 housing flange from roadraceengineering.com or BMC and take it to a exhaust/fabrication shop to have them make you a down pipe.
Jeff |
Re:crx t25 - o2 housing/downpipe question
thanks for the replies. I will prob have it fabricated.
|
All times are GMT -5. The time now is 07:00 PM. |
© 2024 MH Sub I, LLC dba Internet Brands