crx t25 - o2 housing/downpipe question
#1
crx t25 - o2 housing/downpipe question
sorry if this has been covered... Ive searched and been reading up, but I havent found much info on this particular issue.
setup: d16a6, hf manifold, dsm t25 turbo
From reading Abaz's comment, the o2 housing/downpipe will not clear the cross member on the crx without cutting it up.
I was wondering how many of you actually did this? and how hard was it? Or, would it be easier buying a flange from BMC and having an exhaust shop make the downpipe tubing?
tia
setup: d16a6, hf manifold, dsm t25 turbo
From reading Abaz's comment, the o2 housing/downpipe will not clear the cross member on the crx without cutting it up.
I was wondering how many of you actually did this? and how hard was it? Or, would it be easier buying a flange from BMC and having an exhaust shop make the downpipe tubing?
tia
#3
Re:crx t25 - o2 housing/downpipe question
you can "Notch" the front cross member if you are comfortable with that, but the DP is going to make a very sharp bend in order to come back up since it will be sitting fairly low. Your better off buying a o2 housing flange from roadraceengineering.com or BMC and take it to a exhaust/fabrication shop to have them make you a down pipe.
Jeff
Jeff
Thread
Thread Starter
Forum
Replies
Last Post
pa2play
Turbo Parts For Sale
3
10-03-2005 09:15 AM
krskid
Wanted
6
08-02-2004 08:18 PM