I read a thread where a guy used either ABS or PVC and it started to deform due to heat.

home deopo. cheap

yes the plastic will deform due to the heat but you can cure that by putting 2 screws in your couplers after the clamps. cant blow off a coupler that is screwd to the pipe

brilliant lmao. here i am with pliers trying to feather the pipes out or grinders trying to make a groove, to welder welding a bead. and i coulda just put a screw in it? doh

its super ghetto but its the only way we could get the charge pipe on my buddies DSM to stay together above 30psi of boost

my ---- was blowing left and right at 12 pounds heh. id get one good pull in second and at like 6k POP. i think it was a mix of home depot couplers, cut up aluminum pipe and the movement from the engine (was always the hot side).

Took a grinder the ground like a reverese bead into it and it worked decent.

but now we know screw that ---- together

did you coat the screw in rtv or anything?

no the amount of boost leak it will have is very very minimal.