Cheap place to find bolts for 14b/16g turbo set up? what size?
#1
Cheap place to find bolts for 14b/16g turbo set up? what size?
As the title states. I was wondering what size the bolts were and where I could get them on the cheap. I need the bolts that attach the turbo to the manifold, Turbo exhaust collector bolts that attach it to the exhaust turbine housing, and collector to downpipe. The bolts I find for sale are exspensive as hell. Is there a site online that sells these at a reasonable price?
thanks in advance
thanks in advance
#3
#5
Stock Manifold to Turbo Bolts (you might not need this much length)
M10x1.25x80
O2 Housing / Turbine Discharge (again, you might not need this much length)
M10x1.25x31
I think you will only find M10x1.25x30 at the average bolt shop and they work just fine as again, you might not need the length. I like Fastenal for getting stuff but some of the small stores don't cut it.
M10x1.25x80
O2 Housing / Turbine Discharge (again, you might not need this much length)
M10x1.25x31
I think you will only find M10x1.25x30 at the average bolt shop and they work just fine as again, you might not need the length. I like Fastenal for getting stuff but some of the small stores don't cut it.
Last edited by BoostGear; 04-26-2009 at 12:19 AM.
#7
i go to ace hardware for all of my bolts. their prices are good and their selection is insane. they even have stainless and grade 8 stuff. you can take the turbine housing in with you and just try bolts in it
#9
#10
Length....... 20mm *I THINK*, not sure, but that would be on a fairly thin (stock) flange, so you might need longer if your using a fatty flange.
I recommend using a HEX head bolt for the j-pipe, it will save you having to make 1/8 turns of the wrench and dinging up your paint/finish.
Thread
Thread Starter
Forum
Replies
Last Post
TTC
Forced Induction
1
11-15-2006 01:46 PM
brax90si
General Discussion
3
06-16-2004 11:50 AM