i was wanting to know if there is anything i need to do to the studs before installing them; as in loctite or something ;and also do i torque them down to the stock ftlbs or more;just basicaly need to know what to do to install them ;the engine is a sohc ZC(d16a6)

 

come on guys i know some one has used these before on a d16a6

 

put the thead sealer on the threads, hand tighten them into the block, put the head on, torque them to specs

 

They will come with instructions and torque specs. They recommens tightening them more than stock specs.
__________________
Best Car Insurance | Auto Protection Today | FREE Trade-In Quote

 

Just installed mine on my D16z6. Was 60 ft/lbs.

 

I use locktite, and torque the studs in to 10 ft lbs, i do that on every stud install because ive had issues where studs will spin with the nuts. I realize its not reccomended, but it works best 'for me'. 60 ft lbs on a D series... as the above poster said. don't forget to use the lube

 

Make sure the threads inside of the block are really clean and dry. blow them out. They say put the studs in by hand, but I put around a 5-10 ftlb torque on them.

 

Yeah make sure it's clean in there.
I made that mistake...
Bolt ate up the threads in the block

 

I just did mine the other night on my B16. 65ft/lbs and I torqued them into the block a little with an allen wrench.

 

the instructions on mine say 20 ftlbs had to put two nuts on each bolt to make one a jam nut and then used the torque wrench.