adjust boost/psi on internal wastegate???
#11
Re: adjust boost/psi on internal wastegate???
Originally Posted by AccordX2Boost
You could get a new exhaust flange on ebay, that will remove the factory wastegate controller and wastegate, then get an external wastegate and weld it to your manifold...done.
#13
Re: adjust boost/psi on internal wastegate???
I didn't say to get a new manifold, read the paragraph next time before you respond, you said the exact same thing I said. instead of fabricating the "extra pipe" drill a hole in your manifold (existing) and weld in a wastegate, it would be a hell of a lot easier and would not take up as much space.....
#15
Re: adjust boost/psi on internal wastegate???
Originally Posted by jeffescortlx
Look close at the waste gate arm, the actuator is disconnected and replaced with a spring. This set up run's a pretty solid 5psi. It spik's a bit in first gear to around 7psi.
#16
Re: adjust boost/psi on internal wastegate???
you can get a wastegate on ebay for like 40 bucks, and you would have a reliable setup. If you cut the actuator rod it can be dangerous to your engine if not done correctly. You don't want to risk blowing your engine,...do you?
#17
Re: adjust boost/psi on internal wastegate???
Originally Posted by StinkyFeet
how do you adjust pressure? cut the spring shorter?
Just dont be retarted and hold it floored on your first try to test the pressure, and your engine wont blow.