Jspeccrxsir

hello all well i have been checking out the site for a while now and i just took some pics of my new project let me know what u guys think

the old motor its d16z6




the new parts im working with
new head 3angle valve job ported out







the block has been machined new block gaurd ,8lbs flywheel, 6 puck clutch, venom 255 fuel pump, srp pistons,JE rings, srp rods, comp stage 2 cam, crank pullley, balanced crank,












soon i will have the rest of the parts and the way the project is coming along

youdontknowmeee

you better not be using that small turbo in the background

Jspeccrxsir

no that turbo will be for my crx i have a t25 turbo already made for the car

90dx

Looks good.What are your goals with this setup?

Jspeccrxsir

well besides that im going boosted i have no other ideas yet but im still looking for some injectors some 450cc with the clips and the resistor box its cause the RC 310 cc injectors wont do also the wide band and the uberdata but im looking for good prices i still dont know what kind of hp im looking with this swap but hope fully at least in the 13s

90dx

What turbo is going on there?You have a solid bottom end capable of lots of power.I would set my site higher than just getting into the 13's.

MikeJ-2009

No T25's on built bottom ends. The turbo gods will rain down. And I hope that's a fancy ash tray and not something you consider a crank pulley.

projcrxday

well you def. went the ***** out route with the sohc i've got a friend in utah right now that has a 94 4door with a d15 with almost the same internals your running and i believe hes running a t3 with a a/r.63 and exh.60 and hes hitting mid 11's, i think his best run so far has been 11.6 with slicks. so your def. off to a good start, and keep us updated

Jspeccrxsir

well the t25 is just a starter turbo till i get a t3/t4 and plus the car will be used daily driven as well

here are some new parts i got as well

Jspeccrxsir

here are the new pics on how its coming along