.49 a/r vs. .89 a/r ~ What differences would I see?
Thread Starter
0.0 BAR
Joined: Jun 2003
Posts: 12
.49 a/r vs. .89 a/r ~ What differences would I see?
I've currently got a Sunbird turbocharger on my 2.2 S-10 pickup. It has a compressor a/r of .48 and an exhaust a/r of .49
I'm looking at a replacement turbo that has the same compressor a/r, but has an exhaust a/r of .89
What sort of differences could I expect to see if I used this turbo with that much difference in the exhaust a/r?
The S-10 2.2 is not a high-revving engine, and if it came down to a choice, I would prefer to have the boost available at a lower rpm. My current turbo has what I would consider substantial heat damage, chips, and frayed edges on the turbine impeller, but in spite of this it still boosts pretty well. I'm only running 9 psi, and don't plan on going over that until I rebuild my engine to withstand higher boost.
I'm looking at a replacement turbo that has the same compressor a/r, but has an exhaust a/r of .89
What sort of differences could I expect to see if I used this turbo with that much difference in the exhaust a/r?
The S-10 2.2 is not a high-revving engine, and if it came down to a choice, I would prefer to have the boost available at a lower rpm. My current turbo has what I would consider substantial heat damage, chips, and frayed edges on the turbine impeller, but in spite of this it still boosts pretty well. I'm only running 9 psi, and don't plan on going over that until I rebuild my engine to withstand higher boost.
1.5 BAR
Joined: Feb 2003
Posts: 828
Re:.49 a/r vs. .89 a/r ~ What differences would I see?
What turbos are these? If they are Garretts you can swap the exhaust housings around, put your .48 AR on the new turbo if its in better shape than your old one. It should only be six bolts holding it on there. The .89 AR will never spoool up on that low reving engine in my opinion.
Thread
Thread Starter
Forum
Replies
Last Post
Darkelvis
Engine Management
4
Mar 28, 2005 05:35 PM
