Ill give you a flange 1/2 off, just dont weld that directly to the head, lol.

 

Didnt Jeffs turbo Kia have a manifold lookin like this or was it different?

 

what kinda tube is those? diameter? tickness?

 

Shh.....

 

I will sell u a flange for shiped

 

Yah i sorta took jeff's reverse ramhorn he made for the Kia, but since i built this POS from memory, then checked out jeff's, it's a little different.

PS the welds suck, i wanted to cheet and do just one pass; shoulda done a base fusion pass, then a final pass with filler, back purging the whole thing on both passes... next time i guess.

Oh i used Sch.10 1.5" weld els and piping, all 304 ss.
Flanges are just not on yet, i got em, but thanks anyway

ANNNNDDD, i'm serious about the ALu stainless rod.....

 

thats sweet looking manifold. but how are you sure its going to fit the flange by welding it without the flange? did you use a gasket to get it lined up?

 

I think you should cut it up and start over it sucks JK. When you installing that on Peters car then? I think you should grind the welds and start over Hacky Mchackerson...................





Its pretty sweet in person i must say hes getting better at it thats for sure....................



Tommy@Kineticmotorsport.com

 

---- that... duct tape, JB weld, and bubble gum... and not the cheap bubble gum that falls apart after 2 minutes of chewing... gotta get the good stuff like BubbleYum

 

new pics at top....