Something different: P/S rack to manual steering rack bushing
03-22-2007, 08:55 PM
#1
0.0 BAR
Thread Starter
Join Date: Oct 2003
Posts: 0
Something different: P/S rack to manual steering rack bushing
this is going into a DA integra that is being prepared for touring class racing... they were swapping out the p/s rack for a manual one out of a crx and the es bushing didn't fit the smaller diameter manual rack so i made up a split bushing out of delrin to fill the gap. i would have made a whole new bushing out of delrin that could be bolted together but local suppliers wanted $25 for a 4" piece of 2.5" round delrin! i already had the 2" so i made the sleeve instead. if it doesn't work out well i'll just make a whole new one out of aluminum.
new rack:
close up of the delrin sleeve with the es poly that fits the p/s rack:
sleeve installed, note it fits snug enough to hold itself on without falling off:
now the es poly bushing overtop:
ready to shred corners!
new rack:
close up of the delrin sleeve with the es poly that fits the p/s rack:
sleeve installed, note it fits snug enough to hold itself on without falling off:
now the es poly bushing overtop:
ready to shred corners!
03-22-2007, 10:35 PM
#3
3.0 BAR
Join Date: Jul 2004
Posts: 2,255
Re: Something different: P/S rack to manual steering rack bushing
Why arent you to confident that will work?
I cant see that failing for any reason other than the material (never heard of it) breaking down
Whats that ---- used for or made out of?
I cant see that failing for any reason other than the material (never heard of it) breaking down
Whats that ---- used for or made out of?
Thread
Thread Starter
Forum
Replies
Last Post
95civicLX
General Discussion
5
06-13-2006 03:17 PM
