solfly

anyone have pics of what they took out of the girdle

TGrant

I didnt have to take any out of my girdle. You need atleast .050 clearance between your rods and the block.

fourthgenhatch

man this sounds like some ---- i would do. just can't wait huh? it's a bummer being that anxious. oh well, you'll figure out if you notched it far enough when you get the rods

superd

u diff. didnt go far enough but i say wait till u get the rods ull see then

solfly

ordering the rods tomorrow

vang

def. not far enough. I just threw some tuner toy rods in my d-series and I notched them deeper than that.

2stockrocketz

wait and check the block when you get your rods (put them on the crank and spin them and check your clearence). when i did my build (i had eagle rods, zc block) i called eagle to ask how much do i need to knotch, believe it or not they said no 2 blocks are the same.(and then they told me to do the test fit)

UltimX

1/2" up and to the side. make sure u clean it well.

staticchmbr

endyne says 1/4" up the sleeve, 1/4-1/2" side to side, and 1/4" deep

now when you guys say take ---- off the girdle..was that because the rods were hitting, or because there wasn't enough clearance, so you did it to be safe?

W O T

Your girdle doesnt need ----

ive done 4 motors and havent touched a single one