NOOB needs help, I posted PORNZ
 

http://www.bravoporn.com/updates/200.../f764b6/01.jpg

http://www.bravoporn.com/updates/200.../f764b6/02.jpg

http://www.bravoporn.com/updates/200.../f764b6/03.jpg

http://www.bravoporn.com/updates/200.../f764b6/06.jpg

http://www.bravoporn.com/updates/200.../f764b6/08.jpg

http://www.bravoporn.com/updates/200.../f764b6/09.jpg

http://www.bravoporn.com/updates/200.../f764b6/10.jpg

http://www.bravoporn.com/updates/200.../f764b6/11.jpg

http://www.bravoporn.com/updates/200.../f764b6/12.jpg

http://www.bravoporn.com/updates/200.../f764b6/13.jpg

http://www.bravoporn.com/updates/200.../f764b6/14.jpg

http://www.bravoporn.com/updates/200.../f764b6/15.jpg

WELL THERES THE PORN, AND HERES THE QUESTION........ PLEASE DON'T GET ANY CUM ON MY THREAD LOL'S


OK, THE SHOP THAT WAS REBUILDING MY TURBO CALLED, AND SAID THERE IS A HAIRLINE CRACK ON THE EXHAUST SIDE OF THE TURBO. I HAVE A BUDDY THAT'S A WELDER, BUT HE SAYS THERE ARE DIFFRENT RODS THAT YOU USE TO WELD CAST IRON. AT LEAST THATS WHAT I THINK THE EXHAUST SIDE OF THE TURBO IS MADE OUT OF. WELL I KNOW YOU GUYS WELD ALOT OF ----; WHAT WOULD BE THE BEST ROD TO USE?

Re: NOOB needs help, I posted PORNZ
 

u need a high nicle rod(ni-rod)
but realy if its cracked its gonna kep going

Re: NOOB needs help, I posted PORNZ
 

WELL ITS ONLY AN INCH, I'M JUST GONNA GRIND A CANAL AND FILL IT WITH A WELD SEAM, AND THEN GRIND ALL THAT DOWN, I'M GETTING THE TURBO BACK AT 6PM I'LL POST PICS RIGHT THEN. I HEARD IF YOU USE RODS, THE HEAT WILL MAKE IT EXPAND, AND ITS GOING TO MESS UP OR SOMETHING ALLONG THAT LINE.

Re: NOOB needs help, I posted PORNZ
 

its called caps lock,

also you suck at the interwebz, buy a new turbo

Re: NOOB needs help, I posted PORNZ
 

get a new housing, filling it wont matter

Re: NOOB needs help, I posted PORNZ
 

I'll fix your turbo if you TURN OFF YOUR ------- CAPS LOCK

Re: NOOB needs help, I posted PORNZ
 

your porn is red X'd bitch.
high nickle rod, but it is alot of effort to weld cast iron. It takes pre-heat and post heat and to stress relieve it you weld alittlebit, weld somewhere else then peen it, repeate

Re: NOOB needs help, I posted PORNZ
 

This post sucks.

Re: NOOB needs help, I posted PORNZ
 

+1

Re: NOOB needs help, I posted PORNZ
 

Just a hairline? Bitch, run that ---- 'til it falls off.