Made a test pipe
#4
Re: Made a test pipe
I suck at welding bungs, I always get them too hot and they warp, even when I turn the wire speed and amps down on my tiny Craftsman welder. Your bung looks good (I'm expecting that to be quoted and butchered btw).
#5
Re: Made a test pipe
Thanks for the comments.
The machine is an Inverter fusion 200hf, a british made machine. It cost me about $1400.
Yeah I find the bung the most difficult to get a good consistent bead as the nut is flat and the tube is round so there's always a gap to work with. Getting better at it though.
The machine is an Inverter fusion 200hf, a british made machine. It cost me about $1400.
Yeah I find the bung the most difficult to get a good consistent bead as the nut is flat and the tube is round so there's always a gap to work with. Getting better at it though.
#7
Guest
Posts: n/a
Re: Made a test pipe
Originally Posted by TorganFM
I suck at welding bungs, I always get them too hot and they warp, even when I turn the wire speed and amps down on my tiny Craftsman welder. Your bung looks good (I'm expecting that to be quoted and butchered btw).
Thread
Thread Starter
Forum
Replies
Last Post
SpankedYA!
Fabrication
120
02-03-2008 06:31 PM
Sinner
General Discussion
18
01-26-2004 11:52 PM