That's a nice downpie!

 

can u reach all the jdm nuts n bolts?? thats a mad tite jdm downpipe!

 

i cut a straight pipe at an angle / then flipped them over each other to create a straight 90

 

no we did have to sacrifice one bolt to get it to clear. but its been on his car since november and it hasn't leaked yet. I can't tell if your being sarcastic or serious but who cares. I did what I could do with the space available. I think it turned out ok. once we wrapped it with exhaust wrap it had a little less than a credit card width from the compressor to the dp. the dumptube was quite a task as well.

 

Yeah I had a ---- of a time cutting a corner with my 3" dp like that right off of the compressor and had to sacrifice a bolt and had to stud another

I dont think itll leak but we'll see

 

k get t 3inch pipe cut in half at a angle after that u have a 90 weld it weld done flow = ----

 

I'm going to tell the turboford guys you said "JDM bends" hehe

Later
Randy

 

lol

 

This is my attempt at searching, I found this old thread and decided to bring it back to life rather than start a new one. I'm in doing the same thing and would like to see some pics of completed dp's with a/c. help a nig nog out.

 

Push pull or drag, we'll give you top dollar for your trade in down here at take the ------- AC out dealership.