Can you smell what JDM's cook'n!?
#1
Can you smell what JDM's cook'n!?
I did some 3" exhaust fab work this week end. I baked the pipes to get that gold look on stainless and purple on mild steel and that's what exactly I got. And this was all done on good ol fluxcore.
#5
Re: Can you smell what JDM's cook'n!?
awesome, i have heard of using aluminum foil wrapped tight and thick, but dont usually have it around when im welding. i have used grease, just a thin layer about a half inch away from the welds to keep them from sticking, but cleaning it up sucks. well, looks good.
#7
Re: Can you smell what JDM's cook'n!?
lincoln's anti-splatter spray. gives off mad smoke but works pretty good and gives it that cool color. I heard WD40 does the same thing. Nice setup though. I would of left it since being so short and close to the engine it would of turned it that color later on and you can't even see any of it anyways in that MRS.
#8
Re: Can you smell what JDM's cook'n!?
looks awesome. I like the undercar mounting of the intercooler rather than on top close to the vents. During the pinks install at chris', he had a customers mrs there that had a top mount near those grilles. It didnt look like the intercooler would get any airflow unless there was a scoop behind it. Plus, you know its gonna get heat soaked when sitting still. Nice work! More details/pics on the setup please
#10
Re: Can you smell what JDM's cook'n!?
t3/to4e 57 trim
630cc inj.
Apexi Power FC ECU
Greddy Profec B Spec II Boost control
Zeitronix wideband & EGT
FC datalogit
12x22x3 intercooler
2.5 charge pipes
3.0 turbo back
HKS SSQ BOV
Tial 38mm WG
The car is street tuned right now so no power figures yetbut its set at 10psi
My next mod will be cams, pistons and rods and possibly an ITB setup. I already have the hardware for the itb I just cant weld aluminum right now with my Harbor Freight TIG :<
630cc inj.
Apexi Power FC ECU
Greddy Profec B Spec II Boost control
Zeitronix wideband & EGT
FC datalogit
12x22x3 intercooler
2.5 charge pipes
3.0 turbo back
HKS SSQ BOV
Tial 38mm WG
The car is street tuned right now so no power figures yetbut its set at 10psi
My next mod will be cams, pistons and rods and possibly an ITB setup. I already have the hardware for the itb I just cant weld aluminum right now with my Harbor Freight TIG :<