anealing your manifold
#1
anealing your manifold
why dont people do this? with welds in some places and un heated metal in others and unseen stresses pulling at eachother. i would imagine you could reduce cracks and have a manifold last alot longer. plus it softens the metal and could allow for more flex.
#4
Re: anealing your manifold
On cages and stuff like that you can either send it out or warm with a torch until a dull red. Then let it air cool or even better yet slow down the cooling. Does it matter on a manifold. Most likey not, but does it hurt, most likey not.
Randy
Randy
Thread
Thread Starter
Forum
Replies
Last Post
pa2play
General Discussion
24
06-21-2004 08:04 PM
miss-piggy
General Discussion
30
12-13-2003 08:01 PM