Anyone know where i can get one? I searched the www.apexi-usa.com website and found nothing under the applications.

The d16a1 is an 87 integra engine and it only has listings for b18c and b16a engines on the apexi site.

Is there any other wiring diagram that can work or anyone have a link to where i can get one?


Thanks in advance

 

o/~ LA LA LA LA LA o/~

http://www32.brinkster.com/tjshondas/d16a1swap1.html

Pay attention to the 85-87 CRX Si wiring, it is the same thing as your 86-87 Pigtegra. You still have to guess a bit which wires are which, but it narrows things down so you can figure it out with a multimeter. Have the key on, engine off while you fool about.

TPS will have three wires, power, grounds, and signal to ECU... the signal will be ~0.5 volts with throttle closed and ~4.5 with throttle open. The MAP has three wires, also power, ground, and signal to ECU.... the signal wire should be ~3.0 volts with the engine not running.

The others are more or less clearly labelled. Pins A18 or A16 should do equally well for your grounds, make sure they are grounded in the manner the AFC instructions recommend.

When you figure out wire colors and pinouts for your Integra, please post them up here for everyone.

 

Wow, thanks for the help. I'll have the help of a friend who is so-so with electronic stuff.

He suggested to me one thing that i would also like to receive advice on. He said that if we hook up the ground and power wires, then we can juss guess everything else...like u said...with a multimeter. Is this ok?

As far as i know, there are two grounds (black and brown) and 1 power (red). Please correct me if i'm wrong.

Thank you once again.

 

Apexi's site has the install directiuons down to the wiring colors. :>