Where should i go for stand alone.
Thread Starter
0.0 BAR
Joined: Aug 2007
Posts: 40
Where should i go for stand alone.
ok I need some advice and also where to go to get it. I want to switch to stand alone. my car is a 97' Civic EX coupe. right now i'm just using a walbro 255lb pump DSM blue top 450cc injectors a AEM wide band 02 and a missing link check valve with a S-AFC for tunning. I'm running perfect air fuel ratio but i want to switch to stand alone so i can fine tune it and pull some ignition timming if needed. I have a p28 ECU and conversion harness so i just need to know where to go with the stand alone. Hondata , Uberdata , Crome etc. and where to goto get here's a list of everything i have done to the car:
97 civic EX coupe
JDM GSR motor and trans and ECU swap.
Turbalar turbo manifold with tail waste gate
Turbonetics 60-1 turbo t4 hot side
HKS V2 SSQ BOV. 2 1/4 cold side I/c pipe with a 2" Hot side
GReddy monster intercooler
Arias low compression pistons with total seal rings
Eagle connecting rods
Stock head valves cams an intake manifold
Exedy Clutch with a ACT street flywheel.
3" turbo back exhaust with straight threw goignt to a magnaflow 3" straight muffler
97 civic EX coupe
JDM GSR motor and trans and ECU swap.
Turbalar turbo manifold with tail waste gate
Turbonetics 60-1 turbo t4 hot side
HKS V2 SSQ BOV. 2 1/4 cold side I/c pipe with a 2" Hot side
GReddy monster intercooler
Arias low compression pistons with total seal rings
Eagle connecting rods
Stock head valves cams an intake manifold
Exedy Clutch with a ACT street flywheel.
3" turbo back exhaust with straight threw goignt to a magnaflow 3" straight muffler
Guest
Posts: n/a
Re: Where should i go for stand alone.
if youre looking into hondata, uber, or crome: www.-------------
Thread
Thread Starter
Forum
Replies
Last Post
TurboBoostedEK
Wanted
6
Jul 25, 2005 03:41 PM
