what else do I need to finish the project
#1
what else do I need to finish the project
OK I have chipped my ECU, have a burner on order, and have a set of 450 injectors. What else will I need as far as fuel management goes to finish the project? I am planning on using Turboedit, do I still need to run the check valves for the map sensor, what about the 3bar sensor? can I scale the 450s back to run well with a 8-10 psi on a stock A6 motor or should I look for something a little smaller. I may have a set of 300s laying around.
let me know what else is required I would like to complete this before school starts back.
let me know what else is required I would like to complete this before school starts back.
#4
Re:what else do I need to finish the project
Why the bigger pump? If the stock pump is good I am not raising the fuel pressure with an FMU so the stock pump should easliy handle the same amount pressure as stock?
Yes the gauges are getting ordered on monday. What do I need a pressure reg for? AS I understand the factory computer will try and lower the fuel flow despite the increase pressure from a FPR.
Yes the gauges are getting ordered on monday. What do I need a pressure reg for? AS I understand the factory computer will try and lower the fuel flow despite the increase pressure from a FPR.
#6
Re:what else do I need to finish the project
Originally Posted by surfer
bigger pump to handle the increase in flow to cope with the 450's not an increase in pressure
Thread
Thread Starter
Forum
Replies
Last Post
boostman101
Forced Induction
14
10-12-2004 03:22 PM