turbo edit bin with higher rpms
#3
Re: turbo edit bin with higher rpms
Originally Posted by Zeniceguycrx
I need a bin with higher then 7400 rpm,Iv tried the basemapper delux but am no good with that ----. does anyone have a bin already made orcanmakeone?
#5
Re: turbo edit bin with higher rpms
I'll bet you $50 your ZC doesn't make power past 7400 RPM. The only reason to raise the limited is ricer appleal, anyways.
Without a significant rewrite of the code it's not going to happen anyways. Last I checked, no one is working on OBD0 anymore.
Bottom line: forget it.
Without a significant rewrite of the code it's not going to happen anyways. Last I checked, no one is working on OBD0 anymore.
Bottom line: forget it.
#6
Re: turbo edit bin with higher rpms
car pulls like a mother ****** till red line! I realy do beleave its good because on the dyno I was still gaining power until the rev limiter.
I dont want a tone of rpm, maybe 800-8500 max
I dont want a tone of rpm, maybe 800-8500 max
#8
Re: turbo edit bin with higher rpms
Originally Posted by blundar
I'll bet you $50 your ZC doesn't make power past 7400 RPM. The only reason to raise the limited is ricer appleal, anyways.
Without a significant rewrite of the code it's not going to happen anyways. Last I checked, no one is working on OBD0 anymore.
Bottom line: forget it.
Without a significant rewrite of the code it's not going to happen anyways. Last I checked, no one is working on OBD0 anymore.
Bottom line: forget it.
Thread
Thread Starter
Forum
Replies
Last Post
azndude1983
Forced Induction
20
02-21-2006 12:33 PM
Turbodelsolman
General Discussion
6
02-23-2003 08:10 PM