pr3 turbo edit/BRE
#1
pr3 turbo edit/BRE
I just chipped my PR3 and started experimenting with TE and BRE. These noob questions but on what happens after 7400 rpm because that is where the tables ends. I was also wondering if i turbo my b16 is it best to run a pm6 and paste in my vtec tables after 5200 rpm and use my shift light to activate vtec. Or is their development for a boosted pr3 rom. Lastly, is there development for launch control for the pr3? any answers would be awesome.
#2
Re:pr3 turbo edit/BRE
Your PR3 actually tunes up to 8200.. but the RPM scalars are unknown at this time.
PR3 is a shitbag ECU. There isn't a lot of support (even from Hondata)
..but, if it's all you have it's all you have. Ther ei no boost support for PR3.
If you want boost support, you'll want to use the TurboEDIT2.0 VTEC ROM when it's available. It'sin it's testing stages right now (THANKS DUSTIN!!!)..
Should be available in a month or so..
PR3 is a shitbag ECU. There isn't a lot of support (even from Hondata)
..but, if it's all you have it's all you have. Ther ei no boost support for PR3.
If you want boost support, you'll want to use the TurboEDIT2.0 VTEC ROM when it's available. It'sin it's testing stages right now (THANKS DUSTIN!!!)..
Should be available in a month or so..
Thread
Thread Starter
Forum
Replies
Last Post
b16crex
Engine Management
3
08-02-2006 11:13 PM
HMT-Admin
Forced Induction
0
08-01-2006 12:25 PM