PLX Device Voltages vs. AFR
#11
Re: PLX Device Voltages vs. AFR
But as far as sending the voltages to the ECU
Do I just input the 0-5volt signal through C16(Stock o2), disable the o2 sensor in my TE code so it stays in open loop and set the Pluggin for ECUControl to the PLX Device instead of the Stock Device?
Do I just input the 0-5volt signal through C16(Stock o2), disable the o2 sensor in my TE code so it stays in open loop and set the Pluggin for ECUControl to the PLX Device instead of the Stock Device?
#17
Re: PLX Device Voltages vs. AFR
Yes this works. I log as a PLX device, then save to Excel.
I wrote a Macro to Convert, It corrispond within 3 decimal Places to my Digital Voltmeter.
I haven't used it to tune yet, but at idle and rev in the shop it works.
I wrote a Macro to Convert, It corrispond within 3 decimal Places to my Digital Voltmeter.
I haven't used it to tune yet, but at idle and rev in the shop it works.
#20
Re: PLX Device Voltages vs. AFR
Would anyone Really be interested in the Macro and The instructions for this. It is a little in depth, as I don not know how many people know how to write Macros and use trendlines.
Seeing as every WB is different and I only know of the DIY and AEM one being non-linear.
Seeing as every WB is different and I only know of the DIY and AEM one being non-linear.
Thread
Thread Starter
Forum
Replies
Last Post
Tell Me Turbo
Forced Induction
5
05-07-2004 08:21 PM