HomemadeTurbo - DIY Turbo Forum
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   Engine Management (https://www.homemadeturbo.com/engine-management-10/)
-   -   OBD1 ecu running obd2 trans (https://www.homemadeturbo.com/engine-management-10/obd1-ecu-running-obd2-trans-40501/)

Chris Harris 06-02-2005 11:56 PM
Re: OBD1 ecu running obd2 trans
 
Originally Posted by Paul99EX

I got my harness from http://www.jkobd.com/, chris refered me to him. He said he tested the harness and it seemed ok, but he mentioned something about the transmission. I'll email him again and try explaining to him whats going on, or since you know him personally chirs, think you mgiht be able to help me out?
Send him an email and copy me in there...

Paul99EX 06-03-2005 06:46 AM
Re: OBD1 ecu running obd2 trans
 
Originally Posted by xenocron
Originally Posted by Paul99EX

I got my harness from http://www.jkobd.com/, chris refered me to him. He said he tested the harness and it seemed ok, but he mentioned something about the transmission. I'll email him again and try explaining to him whats going on, or since you know him personally chirs, think you mgiht be able to help me out?
Send him an email and copy me in there...
we've been emailing each other. I'll copy the email (since i always copy every email into the next one) and post it up.

Paul99EX 06-04-2005 04:15 PM
Re: OBD1 ecu running obd2 trans ***UPDATE***
 
I got my ecu and harness back this week, and i went to start it up, nothing again. It made a different noise this time tho when it was winding. there is a CEL that comes on, now how do I jump the ecu to check the code?

Chris Harris 06-05-2005 10:06 PM
Re: OBD1 ecu running obd2 trans ***UPDATE***
 
Originally Posted by Paul99EX
I got my ecu and harness back this week, and i went to start it up, nothing again. It made a different noise this time tho when it was winding. there is a CEL that comes on, now how do I jump the ecu to check the code?
There is a connector on the pass side, just under the right side of the dash with two holes...stick a paper clip in there.


All times are GMT -5. The time now is 08:21 PM.
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page


© 2024 MH Sub I, LLC dba Internet Brands