needs more help.. btw thanks leed
#2
Re: BIN works fine until I edit it with crome.. wtf?
If possible, try and find out what version of CROME was used to make that bin. Use only that version to edit it.
Opening an older bin w/ 1.4 can do weird stuff. Try 1.2.5 or any flavor of 1.2.* , should work just fine w/ any old bin.
Opening an older bin w/ 1.4 can do weird stuff. Try 1.2.5 or any flavor of 1.2.* , should work just fine w/ any old bin.
#3
needs more help.. btw thanks leed
thanks leed.. yea i actually had to disable some things in options and got them working on 1.4
another question.. i'm going to be boosting when my injectors get here, and i'm not really experienced with tuning.. I have everything including a wideband setup, but i'm just afraid to blow my motor.. so i'm going to be using a base map from xenocrons bin dir that matches mine fairly well..
JoeyBuiltB16.bin
Built B16 , 9.2:1 CP's and Eagle H-Beams , PTE 880cc , SC61 , GM 3 Bar , ITR Cams , Made 387WHP @ 15lbs
^ that's the bin i'm using, but I have 9:1 pistons, venom 720cc injectors, turbonetics t3/t04e 57 trim 60/63, motorola 2.5 bar and GSR cams..
should that map work ok as long as the wideband reads ok or is the map sensor and injectors going to throw everything off? Can I just reset the fuel tables and adjust with cromes fuel tools? thanks for your help
another question.. i'm going to be boosting when my injectors get here, and i'm not really experienced with tuning.. I have everything including a wideband setup, but i'm just afraid to blow my motor.. so i'm going to be using a base map from xenocrons bin dir that matches mine fairly well..
JoeyBuiltB16.bin
Built B16 , 9.2:1 CP's and Eagle H-Beams , PTE 880cc , SC61 , GM 3 Bar , ITR Cams , Made 387WHP @ 15lbs
^ that's the bin i'm using, but I have 9:1 pistons, venom 720cc injectors, turbonetics t3/t04e 57 trim 60/63, motorola 2.5 bar and GSR cams..
should that map work ok as long as the wideband reads ok or is the map sensor and injectors going to throw everything off? Can I just reset the fuel tables and adjust with cromes fuel tools? thanks for your help
Thread
Thread Starter
Forum
Replies
Last Post
RENR
General Discussion
10
01-02-2007 02:04 PM
biggmike
Engine Management
13
12-13-2004 08:08 PM
juli0_bustamante
General Discussion
41
09-28-2004 09:24 PM
Kaneda13
General Discussion
8
05-24-2003 10:48 PM