HomemadeTurbo - DIY Turbo Forum
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   Engine Management (https://www.homemadeturbo.com/engine-management-10/)
-   -   need help ecu will not work (https://www.homemadeturbo.com/engine-management-10/need-help-ecu-will-not-work-79917/)

sikcrx89 07-07-2007 01:10 PM
Re: need help ecu will not work
 
Originally Posted by ricki bobbi
ya it does not flash at all

I also tryed putting this ecu in a friends car with his chip and it did the same thing... and then i put his ecu in my car with my chip and my car ran great so i am sure that it is the ecu it self... do you know if it makes the ecu go back to stock if you cut the jumper wire next to the zif socket??? i was thinking if the ecu runs stock than maybe it was a bad chipping job thanks
yes cut the jumper and it will return to stock

ricki bobbi 07-07-2007 01:25 PM
Re: need help ecu will not work
 
so if the ecu works than do you think that it was a bad chipping job

sikcrx89 07-07-2007 01:42 PM
Re: need help ecu will not work
 
Originally Posted by ricki bobbi
so if the ecu works than do you think that it was a bad chipping job
usually if its a bad chipping job the ecu wont work at all.. is the chip in backwards or is there stray solder anywhere?? if you cut the jumper and all is normal then send it back to whoever chipped it and give them a swift kick in the nuts

ricki bobbi 07-07-2007 01:54 PM
Re: need help ecu will not work
 
thanks man i will try it

reactone 07-09-2007 03:17 PM
Re: need help ecu will not work
 
Sounds like you have a solid cel, when you jump the service connector there will be no code, just a solid cel. This means that it is ecu related in all likelihood. Cut the jumper and see if the cel goes away. Also, if you jump the connector while having no cels, the cel will also be solid, so make sure that there is a cel with the connector unjumped first.

By the way, this is funny:
Originally Posted by jagojon3
Pull it like a chainsaw


All times are GMT -5. The time now is 09:24 AM.
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page


© 2024 MH Sub I, LLC dba Internet Brands