Look at my lambda log
#1
Guest
Posts: n/a
Look at my lambda log
This is just with scaling and then slighty tweaking the entire vaccuum portion of the map at the same time. Sometimes it'll run around 14.7, sometimes around 16. I am running closed loop obviously. When I run open loop do you think the values will be closer to 14.7 all over?
I am running a max of 6 psi right now. I didn't even have to tune the boost portion of the map at all, it looks pretty good to me. Any input/suggestions?
I am running a max of 6 psi right now. I didn't even have to tune the boost portion of the map at all, it looks pretty good to me. Any input/suggestions?
#3
Guest
Posts: n/a
Re: Look at my lambda log
I don't see a 10.27... are you referring to one of the columns?
Woops I'm retarded I see it. I'll remove 4% and see how that works out. Any changes you'd do to the N/A portion? And what group of cells would you change to fix that 16.55?
Woops I'm retarded I see it. I'll remove 4% and see how that works out. Any changes you'd do to the N/A portion? And what group of cells would you change to fix that 16.55?
#4
Re: Look at my lambda log
Originally Posted by CSaddict
I would also remove 4% from you 10.27
If anything.. pull out 12.9%.. that will land you at a 12.1:1 AFR right there..
Thread
Thread Starter
Forum
Replies
Last Post
projekteg
Engine Management
9
07-27-2005 01:40 PM