chiman72

Help after 2 long days of fixing my stupid car I finally got it started and it runs like hell. I have a chipped ecu w/ uberdata to run the 450's. HELP??

Jmunk

Bad chip burn ?

0b00st0

There's your problem. Get rid of uberdata and run CROME.

chiman72

first off I'm using a moates burn1. Well I erased my chip and verified empty and it said "chip not empty" so I tried to reburn anyway and it said burn sucessfull. I used a rom from xenocrons site and it runs better but seems like it misses at idle and a little while a half throttle or so. Anyone have a good bin for a greddy 15g, T25 or 14b w/ DSM 450cc at 5-7lbs

evosol

its possible that you got a bad connection somewhere in between the resistor box and injector wires.

I once had a poor solder connection, which lead to a shitty idle.

BoosTedZSix

you have to put the chip furthest away from the lever, half moon facing the lever.

J-MAN

solid CEL? if so then it is a bad burn.

if not then i would double check the resistor box wiring. thats why i always use the RS resistors, can't mess up one wire

hamburgler

are you sure you installed the injectors right? what i did was install the injectors and scale my map first and then start the car to see how it idles and then installed another turbo part and again started the car to see how it idles and so on that way its easier to trouble shoot.

are you sure its running on all 4? if everything else is good use crome. sounds like the same problem i had. good luck

chiman72

Thanks guys problem is fixed, it was a bad burn but Xenocron made me a new bin and works like a charm.

Cray91

Well that is a non sequitur

If it was a bad burn, then simply applying the bin correctly would have worked.

If it was a shitty map, then someone making a new one is the answer.

So which was it.