help!!! with willem burner(dual power)
#1
help!!! with willem burner(dual power)
1)the burner is reading the flash memory even if its not there.2)some times it erases realy fast then i check to see if its clear and it's not.3 the diagram shows an an arrow with icps above it and pionting to jp84)when i put the chip in my ecm theres etheir a solid cell or a code 10,etheir way i take the chip out with out cuting the jumper and the car runs the same just has solid cell.i'm runing a A29c256 chip with urberdata tuning.Any info would be a great help!!!!!!!!
#2
Re: help!!! with willem burner(dual power)
al right got the solid cel to go a way now the car runs much better!!(had to disable all sensors??)but now there a cel poping up only when the engine is on,tried to jump to get the code all there was was a solid cel WTF aaaaaaaaaaaaaaaaaaaaaaaaaa this crap is realy starting to **** me of!!!!!!!!!any ways if anyone has any info at all please fill free to reply thank!!!!!
#3
Re: help!!! with willem burner(dual power)
Thread
Thread Starter
Forum
Replies
Last Post
projekteg
Engine Management
77
06-22-2006 08:37 AM