audioguru76

im trying to help a buddy of mine to setup his vafcI. the car will not go into vtec at the point that the vafc is set at. i have tracked it down..i think. the rpms on the vafc are reading almost exactly 1/4 of what the factory tach shows. i did not install this unit, so i don't know exactly where the tach wire is tapped. anyone have any ideas?

thanks

Ben Brotherton

audioguru76

sorry, but it is installed on a 2000 civic Si. stock motor/computer.

civicvtecb16a

Are you going off the stock tach? If so the VAFC is a lot more accurate than the stock tach, Does the vtec point that you have set it at correspond wit the RPM read on the Vafc?

Hope you understand!

Matt

audioguru76

i understand that. but what im saying is that if you hold the car at 4k rpm (stock tach reading) the vafc shows only 996. therefore to get vtec to kick in at 5000 rpm (vafc reading) i would have to turn 20k rpm (stock tach)..i didn't hook this thing up, im trying to fix it. any idea what might cause this? is there maybe a setting that is incorrect...also, i don't have the manual in front of me.

thanks

ben

civicvtecb16a

Are you sure that all the settings are correct?

Sensors : 06 in and 06 out?
Car type: 4 upwards arrow?

audioguru76

yup, checked that...anything else? where should the tach wire be tapped?

audioguru76

anything?