I actually used the same BIN I was running at the time in my setup.

I believe it was right after NG48 had been released but I cant quite remember.

Hit me up on AIM and I will help you out, send you my latest BIN if I have to...

So everyone knows, I am using the PM6 based code in my PR4-A01 ECU now...boost is great, VAC maps are poop!

 

Sounds good. I'm not working tomorrow so let me know what time your going to be online.

Thanks

 

can turbo EDIT be used on obd1 cars?

 

nope.

 

I just went back and re-read your post, and then went back to read your old emails to see if I was halucinating.

Let me get the order of events straight:
1) You installed the turbo setup
2) You plugged in stock ECU, car ran fine
3) You plugged in chipped TurboEdit ECU, car ran shitty

Now between #2 & #3...did you change out the injectors too?

Stock injectors are 240cc and you told me you were running 450cc injectors with a 255 walbro pump. Stock ECU should not have run the 450s *fine* and the chipped ECU wouldn't run the stock 240cc injectors very well at all.

Just trying to be sure it's not something really simple...

 

Yes I installed the 450's between #2 & #3.
Wait> I havent installed the 255 fuel pump, I still have the stock one in there could that be the problem?

 

not very likely that the pump would cause these problems for you unless yours is bad anyways.

 

Nope it's not the pump.

I still don't understand it...my car ran fine on that same map and ECU...B18a w/ 450s

 

What could it be then
I basically have the same setup as you, there for my ecu should work on my car too.


Help!