help me plz!
#1
help me plz!
hi i am having major problems with my batronix eprom burner. it is the already assibled version that cost $109.95.... what happens is
1 i open up prog studio
2 i open the .bin file i wont to burn.
3 i double check to make sure the pins are correct by choosing "check programmer and chip", i then set them correctly if needed
4 i click "read ic" to make sure chip is good
5 after confirming step 4 i click program ic. i do not touch ne thing here except for start
6 it starts to program then right around 80% completed it stops and says error and some wiered number and letters....
7 i am totaly pissd and realize i just wasted my 8th 27c256 chip!!!
8 i get on here to ask yall for help....
the wiered thing is, is that i followd the instructions down to the period all the times and it has only programmed a chip once, successfully!!! plz i am in desperate need of help!!! plz i beg yall...
1 i open up prog studio
2 i open the .bin file i wont to burn.
3 i double check to make sure the pins are correct by choosing "check programmer and chip", i then set them correctly if needed
4 i click "read ic" to make sure chip is good
5 after confirming step 4 i click program ic. i do not touch ne thing here except for start
6 it starts to program then right around 80% completed it stops and says error and some wiered number and letters....
7 i am totaly pissd and realize i just wasted my 8th 27c256 chip!!!
8 i get on here to ask yall for help....
the wiered thing is, is that i followd the instructions down to the period all the times and it has only programmed a chip once, successfully!!! plz i am in desperate need of help!!! plz i beg yall...
#3
Re:help me plz!
I just plugged my burner into the back of my laptop, so when it ***** up I know it isnt the cable, you should get e(e)proms so when it does this you can reuse them. I use SST 27SF256 chips from www.batronix.com they are about $4 a pop, well worth it. I can't help you with your problem but every now and then mine throws a ---- fit and wont program anything. What editor are you using?
Thread
Thread Starter
Forum
Replies
Last Post