HELP? ecu product search
im converting from obd0 to obd1, where can i buy the end adapters, and the wireing conections, and everything to make my own harness. please help.
|
Re:HELP? ecu product search
...why are you converting to OBD1? What is the point?
|
Re:HELP? ecu product search
tunability above 7400 rpm?
|
Re:HELP? ecu product search
Build a motor with a valvetrain that needs it, and I'll concede that point... othterwise, that's bullshit.
|
Re:HELP? ecu product search
its becuase im putting in a fully built d16z6 and im doing it the right way and not just hooking a rpm switch up,
|
Re:HELP? ecu product search
Originally Posted by TurboEF9
Build a motor with a valvetrain that needs it, and I'll concede that point... othterwise, that's bullshit.
|
Re:HELP? ecu product search
Originally Posted by mycrx
...and im doing it the right way...
You realize what a that a VTEC ECU is nothing more than a fancy RPM activated switch? TPS, VSS, Oil Pressure and load.. all limitations of when VTEC would activate. With an RPM activated switch, not only is it cheaper, but will activate any time you hit that RPM. It's not dependent on outside sensor values. Therefore, a single map interface, would be easier to tune because you _know_ your VTEC crossover, and can compensate as such. |
Re:HELP? ecu product search
ya but doesnt when v-tec hits it inputs more fuel so its correct, if i use my old pm6 ecu it will not do this right. if however i do use my pm6 will i lose any power if not running the p28.
|
Re:HELP? ecu product search
No, that's not true at all..
[edit] VTEC ECUs don't "give it more fuel" when VTEC is active, it just switches to a second set of maps that have values enriched for more fuel, which are referred to as "high cam" maps. When you're not in VTEC, you're in "low cam" maps. [/edit] If you are running your PM6, you just enrich your fuel and ignition table for VTEC based on your crossover point. Say like running TurboEDIT on a PM6 to power a B16. You copy and paste your low cam maps below your crossover, and copy and paste your high cam maps above your crossover. Very simple. Especially, now that VTEC through the PS9/PM6 (with hardware changes) is working. |
Re:HELP? ecu product search
where could i get a base map for my pm6, im running turbo and im new to all this so please help me out. and i need help tuning, u know like what all to do and ----. i've checked out pgmfi and turbo edit, but i would like to talk to someone who has experince with it.
|
All times are GMT -5. The time now is 02:46 PM. |
© 2024 MH Sub I, LLC dba Internet Brands