is this a good programmer for uberdata??
#15
Re:is this a good programmer for uberdata??
1) install software to computer
2) plug data cable in to printer port and connect to burner
3) open software and select chip type
4) set dips and jumpers on burner accordingly
5) insert chip in to burner with jumper wire
6) power up chip burner (usb)
7) i.d. test to make sure burner recognizes chip
load .bin in to buffer
9) blank test chip, if not blank, erase
10) program chip
11) take chip out
12) put chip in ecu
13) drive car
14) go pick up some ho's
2) plug data cable in to printer port and connect to burner
3) open software and select chip type
4) set dips and jumpers on burner accordingly
5) insert chip in to burner with jumper wire
6) power up chip burner (usb)
7) i.d. test to make sure burner recognizes chip
load .bin in to buffer
9) blank test chip, if not blank, erase
10) program chip
11) take chip out
12) put chip in ecu
13) drive car
14) go pick up some ho's
#18
Re:is this a good programmer for uberdata??
Originally Posted by projekteg
you just have to install the software on your computer, read the directions that come with the burner, and use a jumper wire between pin 3 and 31 on the burner when burning 29c256 chips.
#19
Re:is this a good programmer for uberdata??
Originally Posted by G2turbo_terror
Originally Posted by projekteg
you just have to install the software on your computer, read the directions that come with the burner, and use a jumper wire between pin 3 and 31 on the burner when burning 29c256 chips.
i think it's just the willem, but i'm not sure being as this is the only burner i've used, but i've never heard anyone mention it with other burners