Re:is this a good programmer for uberdata??
this isn't your exaxt burner, but i drew this little diagram for someone else who had the basic willem, it works the same way...
http://www.we-todd-did-racing.com/we...MXk1NDE%3D.jpg |
Re:is this a good programmer for uberdata??
So you just get a wire and stick it in both pins to bridge them?
|
Re:is this a good programmer for uberdata??
yeah, only for the 29c's though, you don't have to do it with other eproms
|
Re:is this a good programmer for uberdata??
Awesome, always seems dangerous to be prodding electrical stuff wen its plugged in tho lol, do you do it wen its turned on or off?
Matt |
Re:is this a good programmer for uberdata??
1) install software to computer
2) plug data cable in to printer port and connect to burner 3) open software and select chip type 4) set dips and jumpers on burner accordingly 5) insert chip in to burner with jumper wire 6) power up chip burner (usb) 7) i.d. test to make sure burner recognizes chip 8) load .bin in to buffer 9) blank test chip, if not blank, erase 10) program chip 11) take chip out 12) put chip in ecu 13) drive car 14) go pick up some ho's |
Re:is this a good programmer for uberdata??
12) put chip in ecu
13) drive car 14) go pick up some ho's 8) 8) 8) 8) 8) 8) 8) 8) |
Re:is this a good programmer for uberdata??
that was great thanks. ;)
|
Re:is this a good programmer for uberdata??
Originally Posted by projekteg
you just have to install the software on your computer, read the directions that come with the burner, and use a jumper wire between pin 3 and 31 on the burner when burning 29c256 chips.
|
Re:is this a good programmer for uberdata??
Originally Posted by G2turbo_terror
Originally Posted by projekteg
you just have to install the software on your computer, read the directions that come with the burner, and use a jumper wire between pin 3 and 31 on the burner when burning 29c256 chips.
i think it's just the willem, but i'm not sure being as this is the only burner i've used, but i've never heard anyone mention it with other burners |
Re:is this a good programmer for uberdata??
Which one is it on their website?
|
All times are GMT -5. The time now is 09:45 AM. |
© 2024 MH Sub I, LLC dba Internet Brands