HomemadeTurbo - DIY Turbo Forum

HomemadeTurbo - DIY Turbo Forum (https://www.homemadeturbo.com/)
-   Engine Management (https://www.homemadeturbo.com/engine-management-10/)
-   -   ECU question... O_O (https://www.homemadeturbo.com/engine-management-10/ecu-question-o_o-64669/)

Anubis_4_99 Jul 11, 2006 06:58 PM

ECU question... O_O
 
i just finished rebuilding my car (about two weeks ago, lol) and finaly got it to the point where i can start it.. but i just realized i have a PO6 instead of a P28..

i got it with a crome basemap and it wont idle and runs rough under 1K or so..

could the PO6 cause the car to run this rough? timeing is dead on, spark is good, fuel is getting in (although it floods without my foot on the throttle)

i tested with a ecu from a 1.8 liter (i think a P72 if i remember right) and it actualy ran somewhat smoother... but not enough to really make a diffrence

any advice is appriated, im already working on getting the right ecu but any opinions are useful

cberman Jul 11, 2006 08:00 PM

Re: ECU question... O_O
 
the p06 is not ur problem. odds are it is converted to p28 spec, even if it wasnt, ud just lose vtec

hook it up to a wideband. then report bnack

Anubis_4_99 Jul 11, 2006 08:01 PM

Re: ECU question... O_O
 
im putting my wideband in tonight, i'll report the idle but i dont really wanna take it out on the road untill im sure its safe :l

Anubis_4_99 Jul 11, 2006 09:00 PM

Re: ECU question... O_O
 
below 10.0 at 1K rpms :l i have a rich pig on my hands

HMTguy Jul 11, 2006 09:26 PM

Re: ECU question... O_O
 
What engine?

Are you using stock injectors and an unchipped P06?

Anubis_4_99 Jul 11, 2006 09:48 PM

Re: ECU question... O_O
 
D16Z6, 8.5:1 compression, RC550 injectors running a crome basemap, im gonna take the map i have to a shop around me and have em burn me a new one a bit leaner and see how it goes

HMTguy Jul 11, 2006 11:01 PM

Re: ECU question... O_O
 
Sounds to me like the map wasn't scaled down for the 550's

Anubis_4_99 Jul 11, 2006 11:08 PM

Re: ECU question... O_O
 
i trust that it was, i sent specs for it.. i just think that it was too rich.. im gonna have a shop reburn me a leaner map and see what everything is set at

HMTguy Jul 11, 2006 11:15 PM

Re: ECU question... O_O
 
People make mistakes.

A stock Z6 map scaled for your 550's and nothing else done to it should keep your car running at the very least.

Anubis_4_99 Jul 11, 2006 11:20 PM

Re: ECU question... O_O
 
true

its not much of a big deal anyway since my oil line is fubar'd and i need a new one before i can drive anywhere

im going to omaha tomorrow and can get a chip burnt from a tuneing shop somewhere there for pretty cheap


All times are GMT -5. The time now is 09:26 AM.


© 2026 MH Sub I, LLC dba Internet Brands