Ecu pin out question for a p28 in a 94 accord
#1
Ecu pin out question for a p28 in a 94 accord
I am running crome on a p28 in my accord. I got a base map from the PG site, uploaded into the ecu via ostrich. The car will crank and idle but is very rough and rich. i tried decreasing the fuel and advancing the timing a lil bit but it either gets worse or stays the same. I read somewhere that the p28 has 2 wires in a different spot then the accord P0A ecu. does anyone know what 2 wires i have to swap to use the P28 in the 94 accord. the accord is obd1. I think that this is the reason why i cant get the car to idle right. I have did many searches and came back with nothing.
Thread
Thread Starter
Forum
Replies
Last Post
spooolin
Engine Management
2
10-26-2004 07:10 PM