cynosurecivic

i tried searching for the answer to my question, but couldnt find one. when installing 450cc DSM injectors, i know you can install inline resistors, but i was thinking about installing a honda injector resistor box. the only problem is, i dont know where to get one.

where can i find one of these? what vehicle do they come out of? how much can i expect to spend? and how does it install.

thanks in advance for any info.

importpower

You can find them in classifieds on forums such as here or H-T. They come out of OBD0 vehicles. You can spend as little as $10 on one. As for installation check out these links.

http://honda-tech.com/zerothread?id=517274
http://www.honda-tech.com/zerothread?id=222366

thermal

http://www.hstuners.com/forums/showt...threadid=11436

The resistor box is all over the place. Go to your local junkyard and find any 4 cylinder Honda/Acura manufactured from 88-91. I even found some on an 86 lude and 87 teg. They are usually located on the driver side strut tower area. The link above has the picture of what they look like. Trust me, you cant miss it. If not, I'll sell you one for $15 shipped to your door. U.S only tho....

bambooseven

or you could get some inline resistors for like $4 at radio shack

cynosurecivic

i see i see, thanks everyone

pa2play

Ebay, $5