DSM 450 install question... resister box hookup...
#1
DSM 450 install question... resister box hookup...
Yes i read the write up... im picking up a stock injector resistor box for my 95' Eg CX and recently aquired blue top 450's... the write-up tells how to individually put resistors inline... but i need to know how to wire in the resistor box... im picking this up this weekend so havent looked at it yet... can anyone help me out here with some quick help so i can put these bitches in on friday?
oh yea... these are for my Sohc (Y7 block,Z6 head,Y8 intake mani)... that is getting boosted here in a week or two
oh yea... these are for my Sohc (Y7 block,Z6 head,Y8 intake mani)... that is getting boosted here in a week or two
#4
Re: DSM 450 install question... resister box hookup...
You can do it two ways: cutting the yellow/blk wire at the injectors or at the dead end connector. I perfer Injectors for ease of mind but if you like stealth then you would have to get a ohm meter and start checkin the dead end connector. Anyways you need to cut all the yellow/blk wires at the injectors, you will then connect the yellow/blk wires coming from your injectors to one of the 4 black wires coming out of the resistor box. One for each wire, remember its going to the injectors. The rest of the yellow/blk wires that are going back to the engine harness bundle then would have to be all spliced to the red wire coming out of your resistor box. Again not one or just two wires...but all of them have to be spliced to that red wire. Hope that helps.
#5
Re: DSM 450 install question... resister box hookup...
go to google.
type site:www.homemadeturbo.com restistor box install
http://www.honda-tech.com/zerothread?id=441107
go there and then to that llink in there as well.
type site:www.homemadeturbo.com restistor box install
http://www.honda-tech.com/zerothread?id=441107
go there and then to that llink in there as well.
Thread
Thread Starter
Forum
Replies
Last Post