Scott-EP

looks fine to me.

TomBones

Consider this pig raped!!! Just took her out and ripped on her. I have changed the map up some. I had to add some fuel and then I pulled some timing based on some suggestions from somebody over at pgmfi.org. So far the car runs decent. Started getting lean (mid 13s to low 14s) after 4k rpm so I backed off. I have added some fuel and I am going to go give it a try. Feels like the boost should hit a lot harder at lower RPMs. It never really slams you into the seat but it is more of a steady pull all the way threw the RPM range. God danm I need a set of det cans. That is on the list of things to do tomorrow. Here is the timing I am dealing with now.

lilpooh21186

how much boost you running

theidealone

i was gonna ask the same question, but saw his map is only open to 11.2, so im assuming hes running the stock map sensor for now.

TomBones

Yup. I still need to get a bigger fuel pump and 3 bar map so I can crank the boost. Right now I have it set to 7lbs. I will be putting the boost controler on it tomorrow and cranking the boost up to 11lbs *yawn* Once I get the new map sensor and fuel taken care I will be strapping the Holset on it and cranking it to 20lbs

turbo4life

looks good

how much where the pistons i never heard of them and are they forged?

TomBones

$450 with rings. Yes, they are forged. Check out their website. They are pretty bitchen. Lurker just made 429WHP with the same build as me with them. Here are some pics of the actual build.

https://www.homemadeturbo.com/forum/...?topic=91787.0

turbo4life

http://www.importperformanceparts.ne...ons-honda.html

found it thanks ya but whats their limit.. well i see the good they dont expand as much so how much piston to cylinder wall you running on them

theidealone

damn. you pulled an *** load of timing. my tables shows 20 in the last box, on 10 lbs. dohc zc, stock internals...

TomBones

Put a little timing back today I did crank the boost (well, if you could call it that) to 8 lbs. Seems to run prety good. Doesn't spool like it used to but I think that could be timing. Will work that out later. I did rip on it all day today though and I am loving it. Can't wait to get this thing cranked up even more.