is there any way to make it go away? can u jump the wires at the ecu? i am running a p28 with a b18c1 stock chip. im trying to get my car ready for the dyno. got a cel 22. i read it wrong the first time. made sure the pressure switch is good. how much oil pressure should i have going to the switch? is there anyway to bypass the switch without burning another chip?

 

get a chip burnt with the egr disabled?

 

there is no egr on a p28


egr is found on vx motors
h22's
f22's
d16y5

 

ditto this...

You must be running a P13 or P14 ECU or some ----...

 

isnt there egr in integra's? im using a p28 with a b18c1 stock base map. it in the codes for the civic and teg in the haynes manual.

 

theres an egr on my b16. im not sure if i have a sensor for it or not though.

 

I know that on some of the automatic b18a1 there is a egr.

 

i may have read the cel wrong. im gonna check it again today it might be cel 22. vtec pressure switch.

 

meant to say read the wrong code. not cel

 

I had the same problem (CEL 22) and I just disabled the Vtec Pressure Switch in the ROM using eCtune. I think if you connect pins A4 and D6 this will do the same thing.