ZedEx

I know with other widebands you can wire them in to replace your stock narrowband oxygen sensor (Pertaining specifically to PLX's M-300), is it possible to do the same with the Innovate LC-1?

If it makes a difference, I'm am planning on doing this on an OBDII vehicle... I suppose I would just wire it into the primary then.

Any help is greatly appreciated.

Minor Threat

It's in the LC-1 Manual.

omgbossis21

You sure can but be very carefull as the outputs are the only downfall to the whole wideband. One wrong move and your outputs are fried

ZedEx

So it's in the LC-1 Manual? Good, I haven't purchased it yet, I was just doing some research beforehand.

And yeah... Hopefully I don't make a wrong move, that wouldn't be any good.

JonDouglas

Doing it right now.

t3t5

you just splice the 4 wires on ur 02 hook up the lc-1 4 wires. i remember hooking it up and having a cel so i had to ground out a 5th wire then it went away. but yea ur lc-1 can hook up to ur stock ecu unchipped if you want if that is ur question

Oscar

most widebands have 2 analog outputs. one being for the wb, and the other that simulates the narrowband.

Minor Threat

With the LC1, I believe Analog1 is narrowband output, and Analog2 defaults as 0-5V