Sirex

just got my burner and its setup.. i have chips here for it..what position do the chips go in? the notch towards the top where the lever is? and the teeth on the chip go furthest up also right?

rextec

i ordered mine and im sure im going to have the same problem
bump

Sirex

hehe, oh well... ill figure it out eventually.

rextec

let me know if you do

xtensive

The "U" or mark on the end of the chip goes on the side closest to the parallel port. Since it is setup for a 32 pin chip, when you use a 28 pin chip, the chip goes in so the unused 4 slots are also closest to the parallel port. Here is a crude ASCII art dipiction:

| | | | | | | | | | | | | | ==
- - - - - - - - - - - -
| U -------> Parallel port
- - - - - - - - - - - -
| | | | | | | | | | | | | | ==

Mike

Tom-Guy

Thank you, Mike.

Sirex

Thanks a shitload mike..

Sirex

what about them jumper switches
how do those work?
my version is 3.3 of batronix eepromer.

rextec

thanks

Tom-Guy

When you go to select the sort of memory you're using, Prog-Studio will flash a color picture of how to configure your jumper switches. It's cake.