AFR and equiv. voltage settings in lc1
#1
AFR and equiv. voltage settings in lc1
I am trying to adjust the AFR and voltage settings through logworks so they correspond to my settings in Crome.
Do I do this under "Channel" ---> "Configure Channel" --->"LC_1_o2" ?
I assume so, but I am unable to make changes since the selections are "grayed" out and unavailable.
Does this mean I am to go "Channel" ---> "Delete channel" ---> "LC_1_o2"
Will that allow me to make the changes necessary? I had no luck with searching and its such a nice day I'm trying to make some progress while it's still light.
Do I do this under "Channel" ---> "Configure Channel" --->"LC_1_o2" ?
I assume so, but I am unable to make changes since the selections are "grayed" out and unavailable.
Does this mean I am to go "Channel" ---> "Delete channel" ---> "LC_1_o2"
Will that allow me to make the changes necessary? I had no luck with searching and its such a nice day I'm trying to make some progress while it's still light.
#3
Re: AFR and equiv. voltage settings in lc1
My apologies. I realized that several hours after posting this. For some reason the LM Programmer isn't opening. I do not have a db9 serial on my laptop so I am using a Belkin serial/usb converter with the necessary drivers.
Any suggestions?
Any suggestions?
#4
Re: AFR and equiv. voltage settings in lc1
I had the exact same problem with no serial port on my laptop. I bought the exact same cable, now that my LC-1 is rescaled im taking the stupid cable back. $30 is highway robbery! Did you try to reinstall logworks? there are other versions for downloading on thier site.
Thread
Thread Starter
Forum
Replies
Last Post
aracer69
Engine Management
2
06-22-2003 07:37 PM