440cc's in the b16
#1
440cc's in the b16
i am going to run my 440cc injectors in my b16 turbo setup. what i wanted to know is if i turn the fuel pressure up can i run my turbo setup safely with out blowing it up. and i understand it would be running rich. or can i just plug the injectors in and let them work and not stomp on it. i know i need to tune but i will get that done eventually like within the next week. thanks just looking for a temporary
#4
Re: 440cc's in the b16
440cc injs - are yout talking about the supra variety?
They're low impedance, so they may smoke up your ECU if your stock injectors are high impedance.
Run a resistor pack to resolve that issue.
You normally can't run beyond about 70-80 psi on stock injectors before having problems.
If supra 440cc injectors will work, you can get 530+ cc high impedance injectors that work in the same fuel rail.. I've got some FS in the FS section - look for 87-88 rx7 turbo II if you're trying to source them on your own.
Remember, if the injectors are too big, you may have idle resolution problems.
They're low impedance, so they may smoke up your ECU if your stock injectors are high impedance.
Run a resistor pack to resolve that issue.
You normally can't run beyond about 70-80 psi on stock injectors before having problems.
If supra 440cc injectors will work, you can get 530+ cc high impedance injectors that work in the same fuel rail.. I've got some FS in the FS section - look for 87-88 rx7 turbo II if you're trying to source them on your own.
Remember, if the injectors are too big, you may have idle resolution problems.
Thread
Thread Starter
Forum
Replies
Last Post