2.5 Bar install, won't Idle
 

So i just installed my 2.5 bar, car starts, spikes to 2k rpm and dies. If i try to give it gas, it will rev up for a second, then will not respond.

Car is a obd0 Civic, b18b, running turboedit. If i use my old chip and map sensor, it runs perfect. I created a new whole new map from scratch for the 2.5 bar, and i also tried the church7.bin from the bin directory, both do the exact same thing.

Here is a pic of the sensor installed, incase i'm retarded and something looks obviously wrong

http://img227.imageshack.us/img227/7...p002fa4.th.jpg


Here are the voltages with the Key On engine Off

Pin1=.2V
Pin2=Gnd
Pin3=4V

Is this thing fucked? Did i ---- up the install?

Re: 2.5 Bar install, won't Idle
 

Your wiring looks fine, but post a bigger pic. I have never used turboedit, but are there options for different 2.5 bar map sensors?

Re: 2.5 Bar install, won't Idle
 

There, you can click to enlarge. Was it you that i got this one from?

I can't imagine its bad, it was brand new in an ESD bag when i got it. But there doesn't seem to be any other possibilities?

Re: 2.5 Bar install, won't Idle
 

Haha I know, I sold it to you ;) It's straight from Freescale just like the map sensor that I'm using now so I highly doubt that it's bad. But there always is that unlikely possibility.

Does turboedit allow you to customize the voltage outputs corresponding to a certain vac/boost level?

Re: 2.5 Bar install, won't Idle
 

----, i dunno. I'm going to be converting to obd1 as soon as my Dist and o2 sensor arrive and they should be here any day. I've already got a a harness, chipped p06 and a basemap made in crome.

Re: 2.5 Bar install, won't Idle
 

In that case I'd just wait and see if it works with Crome :-\ It should.

Re: 2.5 Bar install, won't Idle
 

I can't see it being a rom editor issue, as i've tried maps that other guys have dyno tuned. I am in Canada and it's probably right around 0 in my garage, i dunno if that would make any difference.

Re: 2.5 Bar install, won't Idle
 

You can't just plug the sensor in and expect it to work. I'm a crome guy, but in crome you had to tell crome that you had a 2.5bar. Stock maps and 2.5bars work on different linear scales (different slope/y-intercept).

Re: 2.5 Bar install, won't Idle
 

As i said in my original post, i made a whole new map from scratch specifically selecting the 2.5 bar sensor, and i've also tried a map that has been dyno tuned for an almost identical setup to mine, including a 2.5 bar map.

Re: 2.5 Bar install, won't Idle
 

I've tried 2 of those freescale motorolla 2.5 bar maps, I must be retarted because I keep wrecking them :1