1wire vtec
#4
Re:1wire vtec
the 1 wire vtec I think you are referring to is some code I wrote to allow PM6, PM7, PG7, PR4, ... OBD0CivicIntegra (wee wiki) ECUs to control the vtec solenoid on a vtec motor.
At this point hardware mods are required.
At this point, it is still a single table - just fill in values above/below vtec point appropriately.
At this point, it works but it is still kidna rough.
At this point, there is no editor support for any of the known working programs - I whip em up with a hexeditor.
What else you wanna know?
At this point hardware mods are required.
At this point, it is still a single table - just fill in values above/below vtec point appropriately.
At this point, it works but it is still kidna rough.
At this point, there is no editor support for any of the known working programs - I whip em up with a hexeditor.
What else you wanna know?