Anybody here know anything about carbs?
#11
Re: Anybody here no anything about carbs?
Originally Posted by c0mpl3x
whats the bitch? a flat bit screwdriver, a pair of needlenose, a big crecent wrench, and something for scraping gasket is all you need to rebuild pretty much any holley.
#12
Re: Anybody here no anything about carbs?
Originally Posted by 90dx
though just had to adjust the float level via the adjustment screw on top of the carb :1
#14
Re: Anybody here no anything about carbs?
Ya i will def clean the ---- out of everything when i rebuild it.There is a big screw on top of the carb that i thought was the mixture screw but its the float level and i think I adjusted way to far out when i was ------- around :1 Now that i found the mixture screw on the bottom i leaned it out a bit and it runs better already.This carb is a 3 barrell or that is what its called as it has two barrells one primary and then two stacked on each other for the secondary as it pulls the top one open with vacum i believe when you hammer on it Good learning experience as i have not fucked with a carb in years.
#15
Re: Anybody here no anything about carbs?
Originally Posted by 90dx
Ya i will def clean the ---- out of everything when i rebuild it.There is a big screw on top of the carb that i thought was the mixture screw but its the float level and i think I adjusted way to far out when i was ------- around :1 Now that i found the mixture screw on the bottom i leaned it out a bit and it runs better already.This carb is a 3 barrell or that is what its called as it has two barrells one primary and then two stacked on each other for the secondary as it pulls the top one open with vacum i believe when you hammer on it Good learning experience as i have not fucked with a carb in years.
#16
Re: Anybody here know anything about carbs?
No it is a Keihn i believe its spelled.I think most Honda carbs are made by them.There is literally 50-100 pieces alot tiny little better not drop it or you will never find again type pieces
#17
Re: Anybody here know anything about carbs?
Originally Posted by 90dx
No it is a Keihn i believe its spelled.I think most Honda carbs are made by them.There is literally 50-100 pieces alot tiny little better not drop it or you will never find again type pieces
Thread
Thread Starter
Forum
Replies
Last Post
hmtmom
General Discussion
29
03-21-2006 06:10 PM
95integrals
General Discussion
18
12-10-2005 08:54 PM
robs99si
General Discussion
12
12-08-2004 07:00 PM
Dr.Boost
General Discussion
4
05-11-2003 03:11 PM