Rebuilt B16A2 head and B16 JE pistons
 

Rebuilt B16A2 head for sale, complete has distributor and VTEC solenoid.

New valve seals, head has been milled just to clean it up/make it flat, a few thou taken off, everything has been apart, inspected and cleaned by my machinist.

Had maybe 70k on it before the rebuild, now it sits at the shop wrapped in plastic.

$ 400 OBO

Also have some JE low compression B16 pistons, they're .020 over, little rough on the skirts but the ringlands check out and I wouldn't hesitate to run them again. Will need new rings.

$200 OBO

Pics will be up tomorrow.

Re: Rebuilt B16A2 head and B16 JE pistons
 

you got a part # on the pistons I need some

Re: Rebuilt B16A2 head and B16 JE pistons
 

Lets see some pic's of them to.

Re: Rebuilt B16A2 head and B16 JE pistons
 

http://img176.imageshack.us/img176/1...tons004xm6.jpg
http://img176.imageshack.us/img176/p...jpg/1/w640.png

http://img176.imageshack.us/img176/9...tons005go5.jpg
http://img176.imageshack.us/img176/p...jpg/1/w640.png

Bump for pictures of pistons. All 4 in the set are in exactly the same shape as this one. I was having a hard time getting good pictures without the flash screwing things up.

Re: Rebuilt B16A2 head and B16 JE pistons
 

how much for the rings and where do i get them

how low will you go

Re: Rebuilt B16A2 head and B16 JE pistons
 

I have same pistons with same bore 81.5, and I had to order them form http://www.jeproseal.com/, they were like $100.
Very good pistons...

Re: Rebuilt B16A2 head and B16 JE pistons
 

would you run these pistons?

Re: Rebuilt B16A2 head and B16 JE pistons
 

Me?

I would, I can probably get you a set of rings if you need them.

I'm not going any lower on the pistons, if they don't sell I'll just use them at some point.

Re: Rebuilt B16A2 head and B16 JE pistons
 

can u get brand new rings
how much would they run

do you got the info sheet like ptw clerances ect?