FS: B Series Drag Manifold and Precison Turbo
#1
FS: B Series Drag Manifold and Precison Turbo
Hello guys. have these laying around and need to get rid of it.
Here it is a Drag Manifold for B series with a Precision T3/T4 turbo
Turbine side reads A/R .63
Compressor side reads A/R .70
Turbo has a 90 degree HKS bend welded to the Compressor outlet
COmpressor snails reads.. M24 EC-1 A/R .70
Stage 3 wheels
This turbo was used very little time and then it was taken out to sell the car..Has been sitting on garage for some time. has some surface rust, nothing major.
Compressor snail has a BLack Coating
spins freely and has very minimal shaft play( i think this is normal)...
would like $450 shipped for all (manifold and turbo) Or $100 + shipping for the Manifold and $325 + shipping for the Turbo (paid $700 new + Shipping).
Pictures:
Here it is a Drag Manifold for B series with a Precision T3/T4 turbo
Turbine side reads A/R .63
Compressor side reads A/R .70
Turbo has a 90 degree HKS bend welded to the Compressor outlet
COmpressor snails reads.. M24 EC-1 A/R .70
Stage 3 wheels
This turbo was used very little time and then it was taken out to sell the car..Has been sitting on garage for some time. has some surface rust, nothing major.
Compressor snail has a BLack Coating
spins freely and has very minimal shaft play( i think this is normal)...
would like $450 shipped for all (manifold and turbo) Or $100 + shipping for the Manifold and $325 + shipping for the Turbo (paid $700 new + Shipping).
Pictures:
#6
Re: FS: B Series Drag Manifold and Precison Turbo
It should say what it is on the underside of the compressor housing. Right about where the elbow is welded on. To me it looks like a stage 5/60-1 in an S housing. Definitely could be an older SC61. That's not a stage 3 turbine wheel though. There looks to be a little bit of wear to the turbine wheel too, but maybe it's just the pictures. I need the damn backplate off that turbo! I may just buy the whole thing off you. I'll PM.